Biflex Mikron
Product Overview
Biflex Mikron Insectide provides lightning-fast control and enduring residual protection from the powerful combination of two active ingredients in a cutting edge microemulsion formulation.
Product Description
The unique microemulsion formulation of Biflex Mikron features a particle size that is 200 times smaller than SC formulations and thousands of times smaller than micro-encapsulated products, providing many advantages for pest controllers:
-
Clear Formulation – helps eliminate the possibility of staining or messy, visible residue.
-
Better Insect Penetration – smaller particles are more readily absorbed through an insect’s cuticle for faster control.
-
Increased Uniform Coverage – the increased number and even distribution of particles on a treated surface create a higher probability of insects coming in contact with an effective dose.
-
Stays in Suspension – once mixed, Biflex Mikron remains in suspension and does not require constant agitation.
Key Product Facts:
-
Active ingredient: Bifenthrin 64 g/L & Acetamaprid 53g/L
-
It can beused to form residual surface treatments on porous and non-porous surfaces or to directly target pests.
-
Registered for internal and external use
-
HACCP Certified
Downloads
Use & Safety
Application rates and delivery
Safety instructions- May irritate the eyes. Avoid contact with eyes.
- When preparing the spray and using the prepared spray wear cotton overalls buttoned to the neck and wrist (or equivalent clothing).
- Wash hands after use.
- After each use wash gloves and contaminated clothing.
- Half fill the spray tank with water.
- Shake Biflex Mikron before use.
- Measure the required amount of Biflex Mikron using the label recommended rates.
- Pour the measured dose of Biflex Mikron into the sprayer.
- Add the remaining water, close sprayer, shake and pump to correct pressure and apply spray.
- Refer to product label for more information.
Rate of Application
- Non-porous surfaces: Apply as a coarse spray at the rate of 1L of emulsion per 20m² ensuring thorough coverage of the treated surfaces. When treating non-porous surfaces do not exceed the point of run-off.
- Porous surfaces or use through power equipment: Spray at the rate of 1L of emulsion per 10m² ensuring thorough coverage of the treated surfaces. When treating porous surfaces do not exceed the point of run-off.
- Refer to product label for more information and other use cases.
Timing
- Refer to product label.
Similar Products
Temprid 75 AU & NZ
Suspension ConcentrateTemprid75 is a general insecticide that will control most...
See productCislin 25 AU & NZ
Suspension ConcentrateCislin 25 Professional Insecticide is a premium quality...
See productSuspend Flexx AU
Suspension ConcentrateSuspend® Flexx is a new, innovative general insecticide...
See product